ProductCenter
Contact Us
Foshan Tian plastic building materials Co., Ltd.
Mr. Wang:135-4999-8639
Mr. Ma:139-2323-7563
Address: Foshan City Xin Cun Beijiao town Shunde District East Industrial Zone No. 17
ProductIntroduction:
PC wave tile is a kind of high quality, excellent tenacity of polycarbonate wave board, for its characteristics such as high impact, pervious to light, clear, light, diversity and ultraviolet resistance, PC wave tile show excellent weather resistance, durability, and fireproof performance.
- ProductDetail
- ProductSpecificationAnd parameters
- Applications
- Care and Cleaning
Installation requirements:
1, transverse lap two waves, longitudinal lap 300 mm or more
2, pyramidal purlin span 600 mm or less. The round arch purlin span 800 mm or less
Handling instructions
1, to gather the plate loading and unloading, avoid pick by the bottom plate and plate exposure to drag at both ends and damage the plate surface.
2, plate, pattern should be packed in strong and flat on the ground, the top and the bottom of the heap and must have the scrap board protection, heavy objects placed on it, is strictly prohibited to avoid picking plate brittle crack.
3, workers loading and unloading plate, must have one person every three meters, and clasped her hands on either side of the plate, highly consistent with the head with your hands, and avoid the broken plate.
4, once every 2 or 3 piece of loading and unloading.
5, to gather the plate pattern, and the height of each pile can't higher than 0.75 meters.
6, to in the process of the roof plate assembly, longitudinal and transverse bending is forbidden, in order to avoid the fracture.
Construction conditions:
Wave tile construction must abide by the AS/N2S1562. 3, 96. Here are some matters needing attention of construction:
1, after laid, set aside by the location of the plate; Construction conducted by eaves gradually in the direction of the roof. Plate through the buttons on the side of the steel plate wave.
2, plate in front of the fixed guide hole, fixed screw diameter must be greater than 6 ~ 9 mm in diameter, as heat bilges cold shrink.
3, to gather the plate and steel plate in the longitudinal lap, minimum there must be 200 mm overlap, and post two water-stop.
4, to gather the plate fixation, must use good water washer, make between screw and mining plate, so that the waterproof and dustproof.
5, after flashing the gasket set into the screws, using electric drill lock into the purline, mining plate fixed work is completed.
6, to gather the plate construction, it is forbidden to feet directly on the crest, lest plate cracking, must be in the horizontal position of the mining plate, placed a 1200 mm x 300 mm (length * width) antiskid planks, foot on it for the guide hole of plate and the fixed screw work.
